Management of Billet Temperature and Preheating HeaterFT Series
Measure the temperature of induction-heated billet material, check the degree of similarity with the target value and record the result.
Steel
On worksites in the steel industry, many different materials are used in continuous processes. If manufacturing conditions are not set properly, the risk of producing defective targets increases. Consequently, manufacturing conditions must be managed continuously and the introduction of IoT is becoming an essential technology.
Continuous casting
Flow Management of Mold Release AgentFD-Q Series
Convert the flow rate of mold release agent to digital numeric values to enable automatic management of the equipment.
Rolling
Checking the Gap Between RollersIG Series
Continuously measure the gap between rolling rollers to check and record the result.
Steel Sheet Width Management During RollingIG Series
Continuously measure the actual width after rolling to check and record the result.
Cutting and winding
Height Control of a Steel SheetIL Series
Check the sagging of a steel sheet to adjust the transfer speed automatically.
Managing the Roll Chucking Position of a SlitterIL Series
Automatically determine and switch the roll chucking position depending on the product type.
Speed Control Based on Winding AmountIL Series
Check the winding amount to control the winding operation automatically.
Other
Management of Product DimensionsIL Series
Record the dimensions of products at shipment.
Related pages
- Management of Billet Temperature and Preheating Heater
- Checking the Gap Between Rollers
- Management of Product Dimensions
- Managing the Roll Chucking Position of a Slitter
- Flow Management of Mold Release Agent
- Steel Sheet Width Management During Rolling
- Height Control of a Steel Sheet
- Speed Control Based on Winding Amount
